Replacing An Xbox DVD Drive Nomainot Xbox DVD Drive

My XBOX DVD drive was slowly going bad, so I decided to replace it. Mans XBOX DVD disku bija lēnām iet slikti, tāpēc es nolēmu to aizstāt. Figured it would give me something to do while I search for a 360. Rakstainas tas dotu man kaut ko darīt, kamēr man meklēt 360.

  • Open the case Open lieta

There are 6 #20 Torx screws on the bottom of the case. Ir 6 # 20 Torx skrūvēm no apakšas gadījumā. Each is hidden under stickers or the padded feet on the case. Katra no tām ir paslēpta zem uzlīmes vai polsterētiem kājas uz lietu.

  • Take out the old drive Izņemiet veco disku
  • To remove the old drive, simply remove 2 #10 Torx screws from the plastic bracket attached to the DVD drive. Lai izņemtu veco disku, vienkārši izņemt 2 # 10 Torx skrūvēm no plastmasas iekava pievienots DVD disku.
  • Then, push in the plastic tab (noted above) and gently pull up on the drive. Tad iespiediet plastmasas cilnē (minēts iepriekš) un viegli pavelciet uz diska.
  • The drive is connected to the XBOX with an IDE cable and a power cable. Disks ir savienots ar XBOX ar IDE kabeli un barošanas kabeli. Disconnect both. Atvienot abus.
  • Remove old drive faceplate and place on new drive Noņemt veco drive Faceplate un novietot uz jauno disku

The XBOX DVD drives have a plastic faceplate. XBOX DVD diski ir plastmasas Faceplate. You will need to Jums būs nepieciešams
remove the faceplate from the old drive by pulling out slightly noņemt Faceplate no vecā diska, ko atstājuši nedaudz
then up. tad uz augšu. The process for adding the faceplate to the new drive is Pievienot Faceplate uz jauno disku process
the reverse. otrādi.

  • Slide the faceplate down from the top of the drive door Slaids Faceplate leju no augšas vadīt durvis
  • Place new drive in the case Vieta jauno disku gadījumā

Adding the new drive is the same as removing the old drive… but Pievienojot jaunu disks ir tāds pats kā novērst veco disku ... bet
in reverse. atpakaļgaitā.

  • Attach the IDE and power cables securely, then slip Pievienot IDE un strāvas kabeļi droši, tad buksēšana
    the drive into place iedzīt vieta

You should hear a click when the bracket Jums vajadzētu dzirdēt klikšķi, kad bracket
snaps into place. snaps vietā.

  • Reattach the 2 #10 Torx screws to secure the drive Jauna vajadzēs 2 # 10 Torx skrūvēm, lai nodrošinātu vadīt
  • Close the case Aizvērt lieta
  • Reattach all 6 screws in the case and the rubber feet and you're Jauna vajadzēs visiem 6 skrūves gadījumā un gumijas kājām, un jūs esat
    done! izdarīts!
Comment: Komentārs:
kriss Krišs

July 7th, 2009 7 jūlijs 2009

THANKS FOR THE INFO MY MATE XBOX DVD DRIVE CRASH IT WOULD OPEN BUT NOT CLOSE AND I HAVE A SPARE PC DVD DRIVE AND GOING TO GIVE IT A TRY I HOPE IT WORKS WITH ALL DVD ROMS THANKS Again for the info and i will give you feed back to if you want it Paldies par INFO MY MATE XBOX DVD DRIVE CRASH būtu atvērta, bet nav tuvu UN MAN IR REZERVES PC DVD Drive and gatavojas sniegt IT TRY Ceru, ka tas strādā ar visiem DVD ROM Vēlreiz paldies par info, un es jums dos barību atpakaļ, ja vēlaties